Installation guide

2 – Installation
D000024-000 Rev. A 2-19
Q
Starting at 0x80010000...
sysI
REGS
BOOT
In itializing H yperTransport bus
H yperTransport initializa tion com pleted
F ound In tel Stra ta Flash 128 MBit (0x8918).
Mounted ra w file system on device /image1. (size=6291456 bytes)
Mounted ra w file system on device /image2. (size=6291456 bytes)
Mounted ra w file syst
em on device /dum p0. (size=1048576 bytes)
Mounted flash file system on device /rfa1. (size=2097152 bytes)
Network configuration requ ested.
cliEnabled= 1
sb e0 speed= 100 fullDuplex= 0 flowContro l=0
sb e1 speed= 100 fullDuplex= 1 flowContro l=0
NOTE: The command spineip changes the IP address for image1 and image2
on each managed spine.
2.3.7.5
Enabling 12X Ports (9024 and 9080)
Users can enable 12X ports with the following CLI commands:
❥ ismChassisSet12x: Enables all external ports for 12x. This command has the
following syntax:
ismChassisSet12x <enable12xBit>
The option enable12xBit can be either 1 (enable) or 0 (disable).
For example:
ismChassisSet12x 1
enables 12X on all external ports.
NOTE:Enabling all external ports for 12X may cause some latency issues. It is
recommended that users enable 12X only for the specific ports they need.
❥ ismPortSet12x: Manually enables ports for 12X on a port-by-port basis.This
command has the following syntax:
ismPortSet12x <portName> <enable12xBit>