Installation guide

2 – Installation

D000024-000 Rev. A 2-11

6. Using two screws, install the lower mounting bracket to the rail assembly and

chassis as shown in Figure 2-8.

Figure 2-8. Install the Lower Mounting Bracket and Heyclip

7. Install the heyclip to the rail assembly.

8. If applicable, reinstall the chassis fascia(s).

9. Tighten all screws.

2.3.7

Installing the Switch Fascia

To install the switch fascia(s):

1. On the switch fan side, insert the notches on the top of the fascia into the two

slots on the chassis frame. Snap the bottom of the fascia in place.

2.3.7.1

Installing the Modules (9020, 9040, 9080, 9120 and 9240)

NOTE: The purchased configuration for the SilverStorm 9000 is shipped fully

populated. Follow these steps when it becomes necessary to install or

replace spine modules and leaf modules.

1. Remove the necessary management modules/blanks, spine modules/blanks ,

leaf modules, virtual I/O cards (VICs) and blanks. For detailed instructions,

please refer to the section “Removing a Module or Blank” on page 2-12.

NOTE: If the user is only adding additional modules, remove only the blank(s)

for the slot(s) to be populated. These will not be replaced.

Install the lower rear

mounting bracket to the rail

assembly and chassis

Install the

heyclip here