Installation guide

2 – Installation
Installation Tasks
2-6 D000024-000 Rev. A
Q
2.3.3
Install the Rack Mounting Brackets: 9024-FC
1. Install the appropriate mounting bracket to each side of the switch, using three
(3) #6-32 flat head screws per bracket
2.3.4
Install the Rack Rails (9024-CU, 9020, 9040, 9080, 9120, 9240)
1. Install the caged nuts into the 2 back holes (chassis leaf module side) and the
top and bottom holes (chassis fan side) in the front of the rack.
NOTE:The 2 front holes should match up with the top and bottom holes of the
rail front flange.
All holes should correspond to the rail mounting positions.
2. Fasten the rail back flange (chassis port side) to the rack by installing two screws
into the rail and rack.
Figure 2-1. Rail Back Flange
3. Fasten the rail front flange (chassis fan side) to the rack by installing two screws
into the rail and rack.
Figure 2-2. Rail Front Flange
4. Tighten all rail mounting screws.
Install 2 screws to
top and bottom holes
Install 2 screws to
top and bottom holes