Installation guide

D000024-001 Rev. B C-1
C Serial Port Pinouts
For those users making their own serial cables, follow the guidelines below.
Figure C-20 Serial Port Pinouts
Figure C-20 represents the RJ-11 connector located on the SilverStorm 9024 or
MPFD spine module.
 The only serial port signals required are: Tx, Rx and Ground. All other serial
port signals are NOT used.
Please see Table C-7 for a list of RJ45 (on Digi) to RJ11 cross-references. The
cable should connect the three RJ45 signals (on the Digi) to the RJ11 connector.
The signals for the T3 card located inside the switch and spine are included for
reference only.