Installation guide

B – Safety and Regulatory Compliance Information
Safety Information
B-14 D000024-001 Rev. B
S
Statement 7:
Adding or Replacing Modules - These modules are intended only for installation in
SilverStorm 9000 Series MPFD base units. Always install blanks when removing
an active module. They prevent exposure to energy hazards inside the unit, contain
EMI, and maintain cooling air balance in the chassis.
Verklaring 7:
Toevoegen of vervangen van modules - deze modules zijn alleen bedoeld voor
installatie in MPFD-basiseenheden uit de SilverStorm 9000-reeks. Installeer altijd
plaatshouders wanneer u een actieve module verwijdert. Deze voorkomen
blootstelling aan energierisico's binnen de eenheid, bevatten EMI en handhaven
de koelluchtbalans in het chassis.
Varoitus 7:
Moduulien lisääminen ja vaihtaminen. Moduulit on tarkoitettu asennettavaksi vain
SilverStorm 9000 -sarjan MPFD-perusyksikköihin. Kun olet poistanut aktiivisen
moduulin, muista aina asentaa tyhjä kappale sen paikalle. Ne estävät sähköiskuille
altistumista yksikön sisällä, hillitsevät sähkömagneettisia häiriöitä (EMI) ja pitävät
yllä jäähdytysilman tasaista jakautumista koteloon.
Déclaration 7 :
Ajouter ou remplacer des modules - Ces modules sont conçus exclusivement pour
une installation avec des unités de base SilverStorm 9000 Series MPFD. Installez
toujours des caches de protection lors du retrait d'un module actif. Ils protègent
contre les dangers électriques à l'intérieur de l'unité, limitent l'interférence
électromagnétique et maintiennent un volume d’air refroidissant approprié au sein
du châssis.
Anweisung 7:
Hinzufügen oder Austauschen von Modulen - Diese Module sind für die Installation
in MPFD-Grundeinheiten der SilverStorm 9000 Serie vorgesehen. Installieren Sie
stets leere Module, wenn Sie ein aktives Modul entfernen. Diese verhindern, dass
Stromgefahr im Innern der Einheit entsteht, enthalten Störstrahlung und sorgen für
den Kühlungsausgleich im Gehäuse.
Dichiarazione 7:
Aggiunta o sostituzione dei moduli - I moduli sono concepiti solo per l'installazione
nelle unità di base SilverStorm 9000 Serie MPFD. Quando si rimuove un modulo
attivo, installare sempre le protezioni, poiché impediscono l'esposizione ai pericoli
di scosse all'interno dell'unità, contengono le IEM e mantengono un equilibrio
dell'aria di raffreddamento nel telaio.