Installation guide

2 – Installation
Installation Tasks
2-30 D000024-001 Rev. B
S
FVIC Fibre Channel Port LEDs (9020, 9040, 9080, 9120 and 9240)
Link/Activity
The green Link/Activity LED will blink indicating
 Fibre Channel IO activity on the port. The LED is off when a link is down.
Fault
The Fault LED is a solid Amber LED indicating:
 A fault condition related to the Fibre Channel connection for a specific port.
The Fault LED will be on if a problem is detected in either the Fibre Channel
controller or in the small form factor pluggable (SFP) optical transceiver for a
specific port.
EVIC Ethernet Port LEDs (9020, 9040, 9080, 9120 and 9240)
Link
The Link LED is a solid Green LED indicating
 That the Ethernet port has successfully established a link. The LED is off
when a link is down.
Activity (TX/RX)
The Activity LED is a Green LED indicating:
 There is link activity on an Ethernet port. The LED is off when there is no link
activity.
Spine/Management Module Management LEDs
Each spine module has three management LEDs:
 Capable:
• Green indicates that the spine slot supports management.
• Off indicates that the spine slot does not support management.
 Stat:
• Green indicates that a management board is present.
• Off indicates that no management board is present.
 Act:
• Green indicates that management board is in the active mode. In a
redundantly-managed system, this would indicate the master spine.
• Off indicates that the management board is in the standby mode (if the STAT
LED is Green). In a redundantly-managed system, if the Capable LED is also
Green, this would indicate the slave spine.