Product specifications

3 – Virtual I/O Command Line Interface
Groups and Commands
3-78 D000025-002 Rev. A
S
Sample Output:
NOTE: When an external Ethernet link is removed or otherwise goes down,
aggregation failover can take over and distribute the Ethernet traffic through
other ports in the aggregation. This setting controls the minimum number
of ports that must be remaining in an aggregation for aggregation failover
to run on the specified port. If less than this number of ports are present,
aggregation failover will not be enabled and any remote hosts using that
port will see the link status as down. Aggregation failover is only relevant
for ports in a manual or 802.3ad aggregation. The default setting is '0', which
disables aggregation failover.
ethExtLacpFailoverSet
Modify the number of active ports required for Link Aggregation failover
Syntax:
Options:
Sample Output:
-> ethExtLacpFailoverGet
Port Min Ports for Failover
--------------------------------------
1 [Ext-1 ] : 0
2 [Ext-2 ] : 0
ethExtLacpFailoverSet port min_ports
port
Port (or list of ports) to modify.
num_ports
Minimum number of ports necessary for failover.
-> ethExtLacpFailoverSet 1 2
External Ethernet port 1 [Ext-1]: minimum number of ports for failover
set to 2