User`s guide

5 – Non-Interactive Mode Commands
Non-interactive Commands
SN0054621-00 E 5-17
A
-isns <hba_port_inst> [iSNS IP Address] [iSNSPORT <port_number>]
If you do not specify the [iSNS IP Address] parameter, the command disables
the iSNS client on the specified HBA port.
Issuing this command resets the HBA.
For information on the interactive version of this command, see “iSNS Settings
(CLI Option -isns)” on page 4-21.
-isns6
(iSNS Settings)
To configure the iSNS settings for IPv6 (QLE406x and newer), enter the -isns6
command as follows:
-isns <hba_port_inst> [iSNS IPv6-or-IPv4 Address] [-iSNSPORT
<port_number>]
If you do not specify the [iSNS IP Address] parameter, this command
disables the iSNS client on the specified HBA port.
Issuing this command resets the HBA.
For information on the interactive version of this command, see “iSNS Settings
(CLI Option -isns)” on page 4-21.
-l
(List LUN Information)
Use the -l command to view the following information about LUNs attached to
the selected target:
 HBA/Target/LUN number
 Vendor name
 Product ID
 Product revision
 LUN size
You can view this information for a specific LUN or for all LUNs attached to the
selected target.
To list the LUN information, enter the -l command as follows:
-l <hba_port_inst> <Target ID [LUN ID]>
If you do not include the LUN ID parameter, all the LUNs on the specified target
are shown.
For information on the interactive version of this command, see “List LUN
Information (CLI Option -l)” on page 4-47.