User`s guide

SANsurfer iSCSI HBA CLI
SN0054621-00 B Index-5
Q
SANsurfer iSCSI HBA CLI Application User’s Guide
Command Line Interface for SANblade iSCSI Host Bus Adapters
L
-l 5-3
Large frames 4-8
-lb 5-7
-linkchap 5-9
Login, iSCSI strict login 4-10, 4-16, 4-17, 5-4
Loopback test, performing 4-31, 5-7
LUN
information, listing
4-30, 5-3
number 4-30
product ID 4-30
product revision 4-30
size 4-30
vendor name 4-30
M
MAC address 4-22
Marker IOCB 4-6
Maximum
burst length
4-11, 4-18, 4-25, 5-5
outstanding R2T 4-11, 4-18, 4-25, 5-5
receive data segment length 4-11
Menus
Configure Target Authentication
4-26
Diagnostic 4-30
Display General System Information 4-1
Display Program Version Information 4-1
Display VDP Information 4-34
HBA Information 4-22
List All QLogic iSCSI HBAs detected 4-1
Options 4-2
Set Working Adapter 4-34
Target 4-24
Modes
bootcode
4-20, 5-13
initiator 4-6
interactive 2-1
non-interactive (command line) 2-1, 2-3
session 4-6
target 4-6
ZIO 4-7, 4-16, 4-18
N
-n 5-4
Nagle, CPO (target) 4-25
Nagle, TCP 4-12, 4-16, 4-17, 5-5
Name, iSCSI 4-13
-netconf 5-12
Network settings 4-3, 5-12, 5-13
Network, HBA Network Settings Menu 4-3
Non-interactive mode 2-1, 2-3
O
Operating systems supported by SANsurfer
iSCSI HBA CLI
1-1
P
-pa 5-5
-pb 5-5
-pbootcode 5-14
Persistent bound targets, displaying 5-5
-pinfo 5-10
-ping 5-6
Ping target 4-31, 5-6
Port number 4-11
Port target 4-25
Portal
duplex
4-22
flow control 4-22
link speed 4-22
PPC
installing SANsurfer iSCSI HBA CLI
3-6
uninstalling SANsurfer iSCSI HBA CLI 3-7
Primary
boot target information, clearing
4-21, 5-14
boot target information, setting 4-21, 5-14
DNS 4-13, 4-17, 5-4
target ID, bootcode 4-20
Product ID, LUN 4-30
Product revision, LUN 4-30
Program version 4-1, 5-15
Protocol statistics alarm 4-6
-ps 5-5
-pu 5-6
-px 5-6