User`s guide

5 – Non-interactive Mode Commands
-bootcode (Update Bootcode Code Image)
5-14 SN0054621-00 B
Q
Where:
DCHP mode (3) is valid only when DHCP is enabled.
5.39
-bootcode
(Update Bootcode Code Image)
Type the following command to update the bootcode code image:
-bootcode <HBA No.> <Bootcode Code Image File Name>
5.40
-sbootcodecid
(Set Alternative Client ID)
Type the following command to set the alternative client ID:
-sbootcodecid <HBA No.> <Alternative Client ID>
5.41
-pbootcode
(Set Primary Boot Target Information)
Type the following command to set the primary bootcode boot target and LUN:
-pbootcode <HBA No.> <Boot Target> <Boot LUN>
5.42
-sbootcode
(Set Secondary Boot Target Information)
Type the following command to set the secondary boot target and LUN:
-sbootcode <HBA No.> <Boot Target> <Boot LUN>
5.43
-cpbootcode
(Clear Primary Target Information)
Type the following command to clear the primary boot target and LUN:
-cpbootcode <HBA No.>
1
= Disables bootcode mode
2
= Manual mode
3
= DHCP mode