User`s guide

5 – Non-interactive Mode Commands
-bootcodemode (Set Bootcode Mode (QLA4050/4052 and QMC4052 HBAs))
SN0054621-00 B 5-13
Q
5.35
-dnsdhcp
(Configure IP Settings)
Type the following command to turn on DHCP address resolution to discover the
DNS server address:
-dnsdhcp <HBA No.>
This command is valid only if DCHP is on for the IP configuration.
5.36
-slp
(Display Network Settings)
Type the following command to configure SLP for the HBA port:
-slp <HBA No.> [-OFF] [-DHCP] [-SLPAD <SLP Address>]
Where:
When none of the optional parameters are specified, SLP defaults to auto-discovery
of SLP targets.
DHCP address resolution (–DHCP) cannot be set if DHCP is on for the IP
configuration.
5.37
-binfo
(Display Bootcode Information)
Type the following command to display the bootcode settings for the specified HBA
port:
-binfo <HBA No.>
5.38
-bootcodemode
(Set Bootcode Mode (QLA4050/4052 and QMC4052 HBAs))
Type the following command to set the bootmode mode:
-bootcodemode <HBA No.> <1>|<2>|<3>
-OFF
= Turns off the SLP function
-DHCP
= Turns on the SLP function and uses DHCP to
determine the SLP server address
-SLPAD <SLP
Address>
= Turns on SLP and uses the specified SLP address