User`s guide

5 – Non-interactive Mode Commands
-rdh (Restore HBA Settings)
SN0054621-00 B 5-11
Q
5.31
-rdh
(Restore HBA Settings)
NOTE: This option is not supported in the QLA4010 HBA.
Type the following command to restore the specified HBA port’s settings to their
factory defaults:
-rdh <HBA No.> [A] [F N I T C V S]
Where:
If you want to restore all areas of the HBA port, use the A parameter, or do not
specify a parameter. Otherwise, specify which areas to restore. For example, the
following command restores the firmware and NVRAM to the factory defaults:
-rdh <HBA No.> F N
HBA No.
= HBA port whose factory settings you want to
restore.
A
= Restores the factory settings for the entire HBA
(firmware parameters, network parameters, iSCSI
name, targets, CHAP table, NVARAM, and IPSec).
The HBA will be reset after this command is issued.
F
= Restores the firmware parameters to the factory
default values.
The HBA will be reset after this command is issued.
N
= Restores the network parameters to the factory
default values.
The HBA will be reset after this command is issued.
I
= Restores the iSCSI name to the factory default
value.
The HBA will be reset after this command is issued.
T
= Restores the targets to the factory default values.
C
= Restores the CHAP table to the factory default
values.
V
= Restores the NVRAM to the factory default values.
S
= Restores the IPSec to the factory default values
(QLA4050/4052 and QMC4052 HBAs).