User`s guide

5 – Non-interactive Mode Commands
-n (Configure iSCSI Settings)
5-4 SN0054621-00 B
Q
5.9
-n
(Configure iSCSI Settings)
Type the following command to set to HBA iSCSI parameters:
-n <HBA No.> <Config Name|Config Alias> <Value>
[<Config Name|Config Alias> <Value> …]
The HBA will be reset after this command is issued.
The
<Config Name|Config Alias> <Value> parameter set can be repeated.
These parameters are defined in table 5-2.
Table 5-2. HBA Parameters
Configuration Name Configuration Alias Value
Add Firmware Options
AFW_Device_Timeouts AFWDT on or off
AFW_AutoConnect AFWAC on or off
ExeThrottle ET 0–32768
FirstBurstLen FB 0–32768
IPOptions
IP_ARP_Redirect IPARP on or off
IP_Address IPAD IP address format
IP_Subnet_Mask IPSM IP address format
IP_Gateway IPGW IP address format
Primary_DNS PDNS IP address format
SLP_Address SLPA IP address format
iSCSIOptions
iSCSI_Header_Digests IHD on or off
iSCSI_Data_Digests IDD on or off
iSCSI_Immediate_Data IID on or off
iSCSI_Initial_R2T IIR2T on or off
iSCSI_Snack ISNACK on or off
iSCSI_Discovery_Logout ID on or off
iSCSI_Strict_iSCSI_Login IS on or off
TCPOptions
TCP_SLP_Use_DA SLPDA on or off
TCP_Auto_Discovery SLPADIS on or off
TCP_SLP_UA SLPUA on or off
TCP_SLP_SA SLPSA on or off