User`s guide

5 – Non-interactive Mode Commands
-b (Reset HBA)
5-2 SN0054621-00 B
Q
The positional parameters vary, depending on the command option specified. For
example, to display an HBA’s configured settings, use the command option -C,
followed by the HBA number (positional parameter). In contrast, the command for
providing general information, -g, has no positional parameters.
In non-interactive mode, most changes made to the HBA become effective
immediately. This sometimes will cause the HBA to reset, as specified in the
command description. Be sure the system is prepared for a HBA reset before making
changes.
5.2
-b
(Reset HBA)
Type the following command to reset the HBA:
-b <HBA No.>
The HBA will be reset after this command is issued.
5.3
-c
(Display Configured HBA Settings)
Type the following command to display the configured settings for the HBA:
-c [HBA No.]
When the HBA No. parameter is used, only information for that HBA port is displayed.
When the HBA No. parameter is not used, information for all HBA ports in the system
is displayed.
For a list of HBA settings, see table 4-1.
5.4
-f
(Update Firmware Image)
Type the following command to update the firmware image:
-f <HBA No.> <File Name>
The File Name parameter is the file containing the firmware image to upload to
the HBA.
The HBA will be reset after this command is issued.