User`s guide

SN0054621-00 B 5-1
Section 5
Non-interactive Mode Commands
5.1
Introduction
When operating in non-interactive mode, the command format is as follows:
iscli <Command Option> [Command Variable] | [Command Variable]
Where:
Table 5-1 defines the command variables. Command-specific variables are
described in the command section to which they apply.
NOTE:
■ The commands are case sensitive. For example, -g is not the same as -G.
■ Only one command line option per input file is valid.
<>
= Parameters in angled brackets are required.
[]
= Parameters in square brackets are optional.
|
= OR operator
Italic text
= Placeholder describing the command variable (see
table 5-1).
Table 5-1. Command Variables
Variable Definition
HBA No.
HBA instance from number from the general HBA
information (command -i)
Target ID
Target ID
LUN ID
Logical unit number (0–255)
CHAP Number
Challange handshake authentication protocol (CHAP)
number
CHAP Name
Null-terminated CHAP name, which is sent by the HBA
when responding to the CHAP challenge
CHAP Secret
CHAP secret, which is used by the HBA when generating
the CHAP response
Boot Target
The target ID of the device from which to boot
Boot LUN
The LUN of the boot device