User`s guide

4 – Interactive Mode Commands

Target Menu

SN0054621-00 B 4-29

4.7.6.6

Edit a CHAP Entry

(Command Line Option -edchap)

Perform the following steps to edit a CHAP entry:

1. From the HBA CHAP Menu, type 6 (Edit a CHAP entry), then press ENTER.

2. The CHAP table is displayed. Press ENTER.

3. At the prompt, type the number of the CHAP entry you want to change, then

press ENTER.

4. At the CHAPName [default name] prompt, do one of the following:

■ Type a new CHAP name, then press ENTER.

■ To use the default CHAP name displayed in the prompt, press ENTER.

5. At the CHAPSecret [default name] prompt, do one of the following:

■ Type a new CHAP secret, then press ENTER.

■ To use the default CHAP secret displayed in the prompt, press ENTER.

6. At the CHAPBidi [off or on] prompt, do one of the following:

■ If you want the HBA to authenticate the target (bidirectional CHAP) and the

prompt is CHAPBidi [off], type on, then press ENTER. If the prompt is

CHAPBidi [on], press ENTER.

■ If you do not want the HBA to authenticate the target and the prompt is

CHAPBidi [off], press ENTER. If the prompt is CHAPBidi [on], type off,

then press ENTER.

4.7.6.7

Delete a CHAP Entry

(Command Line Option -delchap)

Perform the following steps to delete an entry from the CHAP table:

1. Type 7 (Delete a CHAP entry), then press ENTER.

2. The CHAP table is displayed. Press ENTER.

3. At the prompt, type the entry number of the CHAP you want to delete, then

press ENTER.

4. Press ENTER again.