User`s guide

4 – Interactive Mode Commands

Target Menu

SN0054621-00 B 4-27

■ Add a CHAP entry (see section 4.7.6.4)

■ Add a default BIDI CHAP (see section 4.7.6.5)

■ Edit a CHAP entry (see section 4.7.6.6)

■ Delete a CHAP entry (see section 4.7.6.7)

4.7.6.1

Display a CHAP Table

(Command Line Option -dspchap)

This option displays the CHAP table, which is an array of records containing CHAP

names and secrets used by the HBA during CHAP authentication. For example:

CHAP TABLE

Entry: 1 <DEFAULT BIDI CHAP entry>

Name:

Secret: carla

This is a BIDI Chap entry

Entry: 2

Name:robert

Secret: qlogic

Entry: 4

Name: carla

Secret: qlogic

Press the Enter key to continue.

4.7.6.2

Display Targets Using CHAP Entries

(Command Line Option -chapmap)

This option displays the following information about each target that has a CHAP:

■ Target ID (target ID of this device as assigned by QLogic software)

■ IP address (IP address of the target)

■ Port (port ID for iSCSI devices as defined by the iSCSI standard)

■ iSCSI name (target iSCSI name as defined by the iSCSI standard)

■ Alias (target iSCSI alias name as defined by the manufacturer software)

■ Name (CHAP name)

■ Secret (CHAP secret)

4.7.6.3

Assign a CHAP Entry to a Target

(Command Line Option -linkchap)

Perform the following steps to assign a CHAP entry to a target:

1. From the HBA CHAP Menu, type 3 (Assign a CHAP Entry to a Target).

2. A list of available targets is displayed. Enter the target ID of the desired target,

then press ENTER.