User`s guide

4 – Interactive Mode Commands
Target Menu
SN0054621-00 B 4-25
Q
4.7.2
Bind Target
(Command Line Option -pb)
This option persistently binds a specific target to the HBA port by saving it in the
HBA flash. Targets that are not persistently bound will not persist across firmware
resets or HBA power cycles.
After selecting the Bind Target option, a list of available targets is displayed. At the
Enter a Target ID: prompt, type the target ID of the target you want to bind.
4.7.3
Unbind Target
(Command Line Options -pu and -px)
This option allows you to unbind one or all targets that are bound to the HBA port.
After selecting the Unbind Target option, a list of available targets is displayed. At
the Enter a Target ID or "ALL": prompt, do one of the following:
■ Type the target ID of the target you want to unbind
■ Type ALL to unbind all the targets that are bound to the HBA port.
4.7.4
Configure Target Parameters
NOTE: This option is not available in non-interactive mode.
This option allows you to modify the following target parameters:
■ TGT_iSCSI_Name
■ TGT_ExeThrottle
■ TGT_FirstBurstLen
■ TGTISCSIO_Header_Digests
■ TGTISCISO_Data_Digests
■ TGTISCSIO_Immediate_Data
■ TGTISCSIO_Initial_R2T
■ TGTISCSIO_Snack
■ TGTSCSIO_Discovery_Logout
■ TGTSCSIO_Strict_Login
■ TGTSCSIO_Error_Recovery_Level
■ TGT_KeepAliveTimeout
■ TGT_DefaultTimeout
■ TGT_MaxBurstLen
■ TGT_MaxOutstandingR2T
■ TGT_Port
■ TGTCPO_Nagle