User`s guide

4 – Interactive Mode Commands

Target Menu

4-24 SN0054621-00 B

4.7

Target Menu

Before making a selection from the HBA Target Menu, perform the following steps:

1. Specify the HBA port whose settings you want to view or change by typing the

number for the Set Working Adapter option, then press ENTER.

2. A list of HBA ports is displayed. Type the number for the HBA port whose

settings you want to change, then press ENTER.

3. Make changes in the submenus, as described in the following sections:

■ List Targets (see section 4.7.1)

■ Bind Target (persistent binding) (see section 4.7.2)

■ Unbind Target (persistent targets only) (see section 4.7.3)

■ Configure Target Parameters (see section 4.7.4)

■ Add a Target (see section 4.7.5)

■ Configure Target Authentication menu (CHAP) (see section 4.7.6)

■ List LUN Information (see section 4.7.7)

4. To update the firmware with these changes, type 8 (Save Target/CHAP

changes), then press ENTER.

5. Type 10 (Refresh), then press ENTER. If you do not select this option, your

changes will not be visible in SANsurfer iSCSI HBA CLI.

4.7.1

List Targets

(Command Line Option -t)

To list all targets connected to the current working adapter, type 1, then press

ENTER. The following information is displayed for each target:

■ Target ID (target ID of this device as assigned by QLogic software)

■ IP (IP address of the target)

■ Port (port ID for iSCSI devices as defined by the iSCSI standard)

■ iSCSI name (target iSCSI name as defined by the iSCSI standard)

■ Alias (target iSCSI alias name as defined by the manufacturer software)

■ State (The target session connection state, for example, no connection, session

active, etc.)