User`s guide

4 – Interactive Mode Commands
HBA Information (Command Line Option -pinfo)
4-22 SN0054621-00 B
Q
4.4.4
HBA Restore Factory Defaults
(Command Line Option -rdh)
NOTE: This option is not supported in the QLA4010 HBA.
This option updates the HBA factory default settings for the following HBA modules:
■ Firmware parameters
■ Network settings (IP, Netmask, DNS, …)
■ iSCSI name
■ Target settings
■ CHAP settings
■ NVRAM settings
After selecting this option, you are asked if you want to restore all of the factory
defaults in the above list. Do one of the following:
■ If you want to restore all the defaults, press ENTER.
■ If you want to restore some of the defaults, type no, then press ENTER. Each
setting displays one-by-one, in the order listed above. To restore the factory
default for that setting, type yes, then press ENTER. If you do not want to restore
this setting, type no, then press ENTER.
The HBA is reset after the parameters are restored.
4.5
HBA Information
(Command Line Option -pinfo)
When this option is selected, the following information is displayed about the working
adapter (see section 4.10):
■ Board type
■ Chip version
■ Serial number
■ MAC address
■ Driver version
■ Firmware version
■ ROM version
■ iSCSI version
■ Bootcode version
■ Connection type
■ Portal flow control
■ Portal duplex
■ Portal link speed (QLA4050/4052 HBAs)