User`s guide

4 – Interactive Mode Commands

HBA Options Menu

4-20 SN0054621-00 B

3. Make changes in the submenus, as described in the following sections:

■ Display Bootcode Information (see section 4.4.3.1)

■ Set Bootcode Mode (see section 4.4.3.2)

■ Set Primary Boot Target Information (see section 4.4.3.3)

■ Set Secondary Boot Target Information (see section 4.4.3.4)

■ Clear Primary Boot Target Information (see section 4.4.3.5)

■ Clear Secondary Boot Target Information (see section 4.4.3.6)

■ Set Alternative Client ID (see section 4.4.3.7)

■ Update Bootcode Code Image (see section 4.4.3.8)

a. For each submenu (except Update Bootcode code Image), save the

changes by selecting Save changes option.

b. To update the firmware with these changes, select the Refresh option. If

you do not select this option, your changes will not be visible in SANsurfer

iSCSI HBA CLI.

4.4.3.1

Display Bootcode Information

(Command Line Option -binfo)

This option displays the following information about the bootcode:

■ Mode

■ Primary target ID

■ Secondary target ID

■ Vendor ID

■ Alternate client ID

■ Version

4.4.3.2

Set Bootcode Mode

(Command Line Option -bootcodemode)

NOTE: If the BIOS version is less than 1.04, this option is not supported (an error

message is displayed).

This option allows you to select one of the following bootcode modes:

■ Bootcode mode enabled or disabled

■ Bootocode manual mode

■ Bootcode DHCP mode (not available unless DCHP is enabled)