User`s guide

4 – Interactive Mode Commands
HBA Options Menu
4-18 SN0054621-00 B
Q
4.4.2.3.6
Configure Advanced Settings
This option allows you to modify the following settings:
■ FW_ZIO_Enable_Mode
■ AFW_Device_Timeouts
■ AFW_Delayed_Ack
■ AFW_AutoConnect
■ ExeThrottle
■ FirstBurstLen
■ IP_ARP_Redirect
■ VLAN_Enable
■ VLAN_User_Priority
■ VLAN_ID
■ iSCSI_Header_Digests
■ iSCSI_Data_Digests
■ iSCSI_Immediate_Data
■ iSCSI_Initial_R2T
■ KeepAliveTO
■ MaxBurstLen
■ MaxOutstandingR2T
■ TCP_Time_Stamp
■ ZIO
Each setting is displayed with the current value in brackets, for example:
KeepAliveTO [30] :
To change the value, type the new value after the prompt. To keep the current value,
press ENTER at the prompt. The next setting displays. The settings are displayed
one-by-one, in the order shown in the above list.
These settings are described in table 4-1.
4.4.2.4
Restore Default HBA Settings
(Command Line Option -rdf)
This option allows you to reset the firmware to the factory defaults. Be sure to select
both the Save changes and reset HBA and Refresh options afterwords; otherwise,
the changes will not take effect.
WARNING!!
These new settings will not apply to currently configured targets,
unless they are first deleted and then configured again after the HBA
is reset.