User`s guide

4 – Interactive Mode Commands

HBA Options Menu

SN0054621-00 B 4-15

a. For each submenu, save the changes by typing the number for the Save

changes and reset HBA option, then press ENTER.

b. To update the firmware with these changes, type the number for the Refresh

option, then press ENTER. If you do not select this option, your changes will

not be visible in SANsurfer iSCSI HBA CLI.

4.4.2.3.1

Edit a Specific HBA Setting

Use this option when you know the name and parameters of the settings you want

to change (see table 4-1 for a list of parameter names and values). All of these

parameters are also available in the following options from the Firmware

Configuration Menu:

■ Configure iSCSI Settings (see section 4.4.2.3.2)

■ Configure Firmware Settings (see section 4.4.2.3.3)

■ Configure Device Settings (see section 4.4.2.3.2)

■ Configure Basic Settings (see section 4.4.2.3.5)

■ Configure Advanced Settings (see section 4.4.2.3.6)

Perform the following steps to edit specific HBA settings:

1. At the Enter the HBA parameter to modify: prompt, enter the name of the

parameter you want to change (see table 4-1 for a list of parameter names and

values).

2. At the Enter the HBA parameter value: prompt, enter the new value.

3. The Enter the HBA parameter to modify: prompt re-displays. Do one of the

following:

a. To modify another parameter, repeat steps 1 and 2.

b. When you are done, press ENTER. The HBA Firmware Configuration Menu

displays.

4.4.2.3.2

Configure iSCSI Settings

(Command Line Option -n)

This option allows you to modify the following HBA iSCSI settings:

■ iSCSI_Header_Digests

■ iSCSI_Data_Digests

■ iSCSI_Immediate_Data

■ iSCSI_Initial_R2T

■ iSCSI_Snack

■ iSCSI_Discovery_Logout