User`s guide

4 – Interactive Mode Commands

HBA Options Menu

SN0054621-00 B 4-13

TCP_Time_Stamp on, off When this parameter is on, a timestamp

is placed in every transmitted TCP

segment. When the receiver responds

with an acknowledge (ACK), the

timestamp is included. Consequently, the

transmitter can calculate the round trip

time (RTT) of the ACK. This value is used

for calculating retransmissions (if

necessary). When this parameter is off,

RTT can only be calculated on one

outstanding segment at a time (rather

than on each segment).

iSCSI_Name

— The target iSCSI name as defined by the

iSCSI standard.

iSCSI_Alias — The target iSCSI alias name as defined

by the manufacturer software.

IP_Address — The IP address of the target.

IP_Subnet Mask — This parameter sets the subnet mask for

the HBA. This parameter is a

four-character array.

IP_Gateway — This parameter indicates the IP address

of the gateway that is available to the

HBA.

Primary_DNS — This parameter contains the IP address

of the primary DNS server that the HBA

uses for obtaining the IP addresses of the

iSCSI devices.

Secondary_DNS

— This parameter contains the IP address

of the secondary DNS server that the HBA

uses for obtaining the IP addresses of the

iSCSI devices.

Secondary_IP_Address

— This parameter specifies the secondary

IP address that the HBA uses for iSCSI

transport and related operations.

Table 4-1. HBA Firmware Settings (Continued)

Parameter Value Description