User`s guide

4 – Interactive Mode Commands
HBA Options Menu
SN0054621-00 B 4-11
Q
DefaultTime2Retain
a
0–65535
seconds
This parameter indicates the maximum
logout time (in seconds) the HBA uses
when negotiating with a device during the
login phase.
DefaultTime2Wait
a
0–65535
seconds
This parameter indicates the minimum
logout time (in seconds) the HBA uses
when negotiating with a device during the
login phase.
MaxBurstLen 0–32767
units (512 to
16 MB-1
bytes)
This parameter indicates the maximum
length for data sequences the HBA uses
when negotiating with a device during the
login phase. This parameter indicates
how many units (512 bytes/unit) of data
the HBA can send/receive. A value of 0
indicates unlimited data units.
MaxOutstandingR2T 1–65535 This parameter indicates the maximum
number of outstanding R2Ts the HBA
uses when negotiating with a device
during the login phase. This parameter
indicates how many R2Ts can be
outstanding on a SCSI task.
MaxRxDataSegmentLen
a
0–65535 This parameter indicates the maximum
data segment size (in 512-byte units) that
the HBA can receive in one PDU.
Port
a
0–65535 This parameter specifies the port number
on which the HBA listens for iSCSI
connections (when operating as a target).
When the HBA is configured only as an
initiator, this parameter is ignored. The
default iSCSI port number is 3260.
TCP_SLP_Use_DA on, off When this parameter is on, the SLP DA
Address field contains the IP address of
the service locator protocol directory
agent (SLP DA) used by the HBA SLP
services. DA discovery is disabled.
TCP_Auto_Discovery on, off When this parameter is on, the HBA
automatically discovers target devices
and creates device database entries for
all devices discovered.
TCP_SLP_UA on, of When this parameter is on, the HBA is
enabled as an initiator to make UA SLP
queries to discover iSCSI targets.
Table 4-1. HBA Firmware Settings (Continued)
Parameter Value Description