User`s guide

4 – Interactive Mode Commands

HBA Options Menu

SN0054621-00 B 4-5

4.4.1.2.2

Using SLP

By default, the service locator protocol (SLP) is disabled.

To enable SLP, press ENTER until the SLP: [off]: prompt displays. Type on, then

press ENTER.

4.4.1.3

iSNS Settings

(Command Line Option -isns)

By default, iSNS is disabled.

Use iSNS when extended discovery management capabilities (such as notifications,

access management, and configuration) are required, such as in larger storage

networks.

To enable iSNS, type on at the SLP prompt, then press ENTER. You are prompted

to enter an iSNS IP address.

4.4.2

HBA Firmware Settings Menu

Perform the following steps to make changes to the HBA firmware settings:

1. Specify the HBA port whose settings you want to view or change by typing the

number for the Set Working Adapter option, then press ENTER.

2. A list of all iSCSI HBA ports is displayed. Type the number for the HBA port

whose settings you want to change, then press ENTER.

3. Make changes in the submenus, as described in the following sections:

■ Display Configured HBA Settings (see section 4.4.2.1)

■ Change HBA Alias Name (see section 4.4.2.2)

■ Edit Configured Hba Settings Menu (see section 4.4.2.3)

■ Restore Default HBA Settings (see section 4.4.2.4)

■ Update Firmware Image (see section 4.4.2.5)

■ Update ROM Image (see section 4.4.2.6)

■ Get Crash Record (see section 4.4.2.7)

a. For each submenu, save the changes by typing the number for the Save

changes and reset HBA option, then press ENTER.

b. To update the firmware with these changes, type the number for the Refresh

option, then press ENTER. If you do not select this option, your changes will

not be visible in SANsurfer iSCSI HBA CLI.