User`s guide

4 – Interactive Mode Commands

HBA Options Menu

SN0054621-00 B 4-3

4.4.1

HBA Network Settings Menu

Perform the following steps to make changes to the HBA network settings:

1. Specify the HBA port whose settings you want to view or change by typing the

number for the Set Working Adapter option, then press ENTER.

2. A list of all iSCSI HBA ports is displayed. Type the number for the HBA port

whose settings you want to change, then press ENTER.

3. Make changes in the submenus, as described in the following sections:

■ Display network settings (see section 4.4.1.1)

■ Configure IP settings (see section 4.4.1.2)

■ Set iSNS settings (see section 4.4.1.3)

a. For each submenu, save the changes by typing the number for the Save

changes and reset HBA option, then press ENTER.

b. To update the firmware with these changes, type the number for the Refresh

option, then press ENTER. If you do not select this option, your changes will

not be visible in SANsurfer iSCSI HBA CLI.

4.4.1.1

Display Network Settings

(Command Line Options -netconf and -slp)

When this option is selected, settings for dynamic host configuration protocol

(DHCP), SLP, and iSNS are displayed. For example:

Using DCHP to obtain an IP Addresses.

IP Address :0.0.0.0

Gateway :0.0.0.0

Subnet Mask :0.0.0.0

Using DCHP to obtain DNS Addresses.

DNS Address :0.0.0.0

SLP Enabled.

Using DCHP to obtain DA Address.

iSNS Disabled.