User`s guide

SN0054621-00 B 3-1
Section 3
Initial Installation
The following requirements must be met before you can run SANsurfer iSCSI HBA
CLI:
■ The HBAs must be installed.
■ The HBA drivers must be installed.
■ You need approximately 1 MB on the PC hard disk to install the SANsurfer iSCSI
HBA CLI application.
NOTE: SANsurfer iSCSI HBA CLI is an application developed to configure
QLogic HBAs. It can only configure HBAs on the local machine upon
which the application is installed; it cannot configure HBAs on remote
machines.
3.1
Installation Instructions
Perform the following steps to download the SANsurfer iSCSI HBA CLI installation
package from the QLogic Web site:
1. From the QLogic home page (www.qlogic.com
), click Support.
2. Click Drivers, Software, and Manuals.
3. Select your HBA.
4. Click the appropriate operating system under the Drivers and Management
Software heading.
5. In the SANblade CLI row of the table, click Download.
6. The File Download dialog box displays. Click Save. Select a directory on your
system and download the file.
The installation package has the following naming convention:
iscli-AA.BB.CC-DD_<OS Type>_<Subtype>.<Install Type>
Where:
AA.BB.CC-DD
= Version number
OS Type
= One of the following:
win
linux
solaris