User`s guide

2 – Getting Started
Non-interactive Mode
SN0054621-00 B 2-3
Q
2.3
Non-interactive Mode
Type the following in a command window to start SANsurfer iSCSI HBA CLI in
non-interactive mode:
iscli <Parameters>
SANsurfer iSCSI HBA CLI executes the command options, then terminates.
To list all of the available command line parameters, type the following:
iscli -h
All command line options must be preceded by the dash (-) notation. Most options
have a corresponding menu selection in interactive mode. The valid command line
options are listed in table 2-1.
Table 2-1. Non-Interactive Mode Options
Non-interactive
Option
Interactive
Menu
Selection
Description Section
-g 1 Display general system
information
4.1, 5.5
-ver 2 Display program version
information
4.2, 5.45
-i 3 List all QLogic iSCSI HBAs
detected
4.3, 5.7
-netconf, -slp, -ipdhcp,
-isns
-c, -f, -rdf, -r, -gcr, -n,
-dnsdhcp,
-binfo, -pbootcode,
-sbootcode,
-cpbootcode,
-csbootcode,
-bootcodemode
-sbootcodecid
-bootcode
-rdh
4 HBA options:
network settings
firmware settings
bootcode settings
restore factory defaults
4.4
4.4.1, 5.33,
5.36, 5.34,
5.28
4.4.2, 5.3,
5.4, 5.30,
5.15, 5.29,
5.9, 5.35
4.4.3, 5.37,
5.41, 5.42,
5.43, 5.44,
5.38, 5.40,
5.39
4.4.4, 5.31
-pinfo 5 HBA information 4.5, 5.27
-b 6 Reset HBA 4.6, 5.2