User`s guide

SANsurfer iSCSI HBA CLI Readme Page 9 of 10
Comapt-glibc-2.5.46.2.x86_64
Compat-libgfortran-41-4.1.2-39.el6.x86_64
Compat-libstdc++-296-2.96-144.el6.x86_64
Compat-libstdc++-33-3.2.3-69.el6.x86_64
Compat-libtermcap-2.0.8.49.el6.x86_64
Compat-openldap-2.4.19_2.3.43-15.el6.x86_64
Openssl098e-0.9.8e-17.el6.x86_64
5. Configure the network and ensure that the iptables/firewall is disabled.
6. Install SANsurfer iSCSI HBA CLI.
7. Install the library RPMs in the following sequence:
libXau-1.0.5.1.el6.i686.rpm
libxcb-1.5.1el6.i686.rpm
libX11-1.3.2.el6.i686.rpm
libXext.1.1.3.2.el6.i686.rpm
libXp.1.0.0.15.1.el6.i686.rpm
8. Run SANsurfer iSCSI HBA CLI.
6.8 SLES 11 SP1 Error Message
In some scenarios on SLES 11 SP1, the iSCSI ports are not discovered, and the following
error message is shown in the system error log:
FATAL: module
'/lib/modules/2.6.32.27-0.2-default/extra/qlgc-qla4xxx/qisioctl.ko'
is unsupported use --allow-unsupported
or set allow_unsupported_modules to 1 in
/etc/modprobe.d/unsupported-modules
To correct the error:
1. To include qisioctl as a supported module for SLES 11 SP1, add in the qla4xxx directory
the Module.supported file with the following contents:
qla4xxx.ko external qisioctl.ko external
2. Rebuild the modules.
3. After loading the qla4xxx driver and before starting SANsurfer iSCSI HBA CLI, load the
qisioctl module as follows:
modprobe qisioctl
NOTE: For details on building and installing the driver and IOCTL module, refer to the Linux
driver Readme document.
7 Known Issues and Workarounds
Known issues in this release, and workarounds (if any) are listed in the following table.
Known Issue Workaround
After installing the drivers, you must restart iscli
to view adapters. Disregard the message about
the need for the reboot.
None. For your information only.
When installing iscli on Linux with an iscli version
that is older than 1.0.39.02, the RPM update
option
-U
does not work correctly.
Use the options -ivh --force. For example:
rpm -ivh --force iscli-1.0.39-02.ppc64.rpm