User`s guide

SANsurfer iSCSI HBA CLI Readme Page 10 of 10
Known Issue Workaround
On Linux 2.6 and newer kernels, you may see the
warning message,
Error Read FW settings from
HBA instance if the adapter is not initialized or is
unable to acquire an IP address using DHCP. This
occurs when the IPv4 address is 0.0.0.0.
Set the IP address to a non-zero value.
iSCSI Adapters are not discovered on Linux
systems.
Ensure that SANsurfer iSCSI HBA CLI was installed
with the script, and not with the RPM file. The
script ensures that a key component, an IOCTL
module, gets installed if it is not already installed
on the system. If you used the script to install iscli
and the iSCSI Adapters are still not discovered,
review the installation messages to determine if
there is an issue installing the IOCTL module.
It is possible that the Linux OS on your system
needs a newer version of SANsurfer iSCSI HBA
CLI
. Check the QLogic Web site to ensure that you
are installing the latest version of iscli.
To verify that the IOCTL module is installed and
loaded, issue the following command:
lsmod | grep qisioctl
8 Contacting Support
Please feel free to contact your QLogic approved reseller or QLogic Technical Support at any
phase of integration for assistance. QLogic Technical Support can be reached by the
following methods:
Web:
http://support.qlogic.com
E-mail:
[e-mail]
Go to Top
© Copyright
2011
. All rights reserved worldwide. QLogic, the QLogic logo, and the Powered
by QLogic logo are registered trademarks of QLogic Corporation. All other brand and
product names are trademarks or registered trademarks o
f their respective owners.