User`s guide

7 – Setting Up Connections
Configuring Targets
7-20 IS0054602-00 A
Q
The dialog box contains three sections:
❑ Set Default Initiator Name and Secret
❑ Initiator Name and Secret
❑ Target Table
4. To enable an initiator name and initiator secret, do the following:
a. In the Initiator Name and Secret section, select the Enable check box for
the targets for which you want to use CHAP.
b. Enter the initiator name and secret you want to use in the Initiator Name
box and Initiator Secret box.
c. Click OK. CHAP is now enabled; the target will use CHAP to authenticate
the QLA4xxx HBA.
5. If you also want the QLA4xxx HBA (initiator) to authenticate the target, perform
these additional following steps:
a. In the Initiator Name and Secret section, select the Bidi check box of the
target you want to configure.
b. In the Target Table section, click the green plus sign (+) on the right. A blank
row displays.
c. Double-click the row in the Target Name box. Enter the target name, which
can be a maximum of 256 ASCII characters. This name must be entered on
the target side (Name) for bidirectional CHAP.
d. Double-click the row in the Target Secret box. Enter the target secret, which
can be a maximum of 100 ASCII characters. This target secret must be
entered on the target side (Password) for bidirectional CHAP.
e. Repeat steps a through d for each target you want to configure. If you want
to remove a target from the Target Table, click the row you want to remove,
then click the red minus sign (–) on the right.