User`s guide

7 – Setting Up Connections
Configuring Targets
IS0054602-00 A 7-17
Q
7.3.3
Changing the Target Configuration Parameters
NOTE: If you changed HBA’s firmware configuration parameter values (see
section 11.1, section 11.2, and section 11.3), a subset of those settings
appear for the corresponding target configuration parameters. Changing
the target configuration parameters will not change the corresponding
HBA’s firmware configuration parameters.
Perform the following steps to edit the target configuration parameters:
1. In the SANsurfer iSCSI HBA Manager main window HBA tree, select the HBA
port. Click the Target Settings tab. Click Config Parameters. The Target
Configuration Parameters dialog box displays (see figure 7-4).
Figure 7-4. Target Configuration Parameters Dialog Box
Note the following about Target Configuration Parameters dialog box:
❑ All targets that display on the Target Settings tabbed page (see figure 7-3)
display here. These include targets that are saved, discovered, newly added,
and discovered through iSNS.
❑ For dynamic targets (discovered using SLP or the SendTargets command),
the values that display are the negotiated values unless these values were
modified using the Target Configuration Parameters dialog box.
❑ For non-dynamic targets, the values that display are the default values from
the saved HBA configured firmware default settings at the time they were
added or the values last configured using this dialog box.