User`s guide

7 – Setting Up Connections
Configuring Targets
7-16 IS0054602-00 A
Q
11. Do one of the following:
❑ Click Save. The QLA4xxx HBA does the following:
❑ Resets (reboots the HBA only) if you have made changes to the firmware
configuration parameters in section 7.3.3
❑ Connects to the target
❑ Makes these new targets available on the Target Settings tabbed page
❑ Right-click the target and select Login/Save Device. The Security Check
dialog box displays. In the Enter Password box, type the password. Click
OK. The QLA4xxx HBA connects to the specific target (without disrupting
any other connections) and saves this configuration.
❑ If you want to log out and then reconnect to the target, right-click the target
and select Logout/Reconnect. The Security Check dialog box displays.
In the Enter Password box, type the password. Click OK.
12. QLogic recommends restarting the host PC for the operating system to
recognize the new targets.
13. The QLA4xxx HBA restarts and attempts to connect to the configured targets.