User`s guide

7 – Setting Up Connections

Configuring Targets

IS0054602-00 A 7-15

7.3.2

Configuring Specific Targets

To configure a specific iSCSI target, follow these steps:

NOTE:

■ If you want to modify these parameters for an existing target, use the

following procedures as appropriate (skipping steps 2 through 5).

■ If you want to delete a target, select the target and click the red minus

sign (–) on the right.

1. In the SANsurfer iSCSI HBA Manager main window HBA tree, select the HBA

port. Click the Target Settings tab. The Target Settings tabbed page displays

(see figure 7-3).

The target configuration section displays the current target configuration and

enables you to configure these and additional targets on this HBA port.

2. In the target configuration section, click green plus sign (+) on the right. A new

row displays.

3. The IP Address dialog box displays. Enter the IP address of the target to which

you want to connect. Click OK.

4. Double-click the iSCSI Name column. Enter the iSCSI name of the target.

5. If you want to enable the target, select the target’s Enable Target check box.

If this check box is not selected, the target is visible, but not accessible, to the

HBA.

6. If you want the targets to be bound to the QLA4xxx HBA, select the Auto-bind

Discovered Targets check box. All targets, whether entered manually or found

using discovery, will be automatically bound to the HBA (the check box in the

Bind column will be selected) when the target configuration is saved.

7. If you want to bind this target to the HBA (the Auto-bind Discovered Targets

check box was not selected), select the target’s Bind check box.

8. Enter other targets as desired.

9. If you want all of the targets to be restored when the HBA is reset, select the

Auto-discover targets (Rediscover Prior SendTargets on Save) check box.

10. If you want to change any of the configuration parameters, follow the

instructions in section 7.3.3.