User`s guide
7 – Setting Up Connections
Configuring Targets
7-14 IS0054602-00 A
Q
8. If you want to enable a specific the target, select the target’s Enable Target
check box. If you want to enable all the targets, right-click on any target in the
table and select Enable All Devices from the pop-up menu.
Conversely, if you want to disable a specific target, clear the target’s Enable
Target check box. Right-click on any target in the table and select Disable All
Devices from the pop-up menu if you do not want to enable any target.
If the Enable Target check box is not selected, the target is visible, but not
accessible, to the HBA.
9. If you want to bind a specific target to the HBA port (the Auto-bind Discovered
Targets check box was not selected), select the target’s Bind check box. If you
want to bind all the targets to the HBA, right-click any target in the table and
select Bind All from the pop-up menu.
Conversely, if you want to unbind a specific target to the HBA, clear the target’s
Bind check box. Right-click on any target in the table and select UnBind All
from the pop-up menu if you do not want to bind any targets to the HBA.
10. Do not change the iSCSI port number unless required.
CAUTION!
The iSCSI port number defaults to 3260. Do not change this
number unless required by the configured target.
11. If you want to change any of the configuration parameters for this specific target,
follow the instructions in section 7.3.3.
12. Click Save.
13. QLogic recommends restarting the host PC for the operating system to
recognize the new targets.
In the following example, there is an iSCSI target at IP address 10.14.64.150. Behind
this target are two available drives with target iSCSI alias names Drive1 and Drive2.
1. In the Target Settings tabbed page target configuration section, click the green
plus sign (+) on the right. A new row displays.
2. The IP Address dialog box displays. Enter IP address 10.14.64.150. Click OK.
3. Leave the iSCSI Name box blank.
4. Click Save.
5. Click the Target Settings tab.
The following three targets display:
❑ IP address 10.14.64.150
❑ IP address 10.14.64.150 with target iSCSI alias name Drive1
❑ IP address 10.14.64.150 with target iSCSI alias name Drive2
6. Restart the host PC for the operating system to recognize the new targets.