User`s guide

7 – Setting Up Connections
Configuring Targets
IS0054602-00 A 7-11
Q
7.3
Configuring Targets
After configuring the QLA4xxx HBA, you can configure iSCSI targets. When the
QLA4xxx HBA arrives from the factory, there are no targets listed. Add iSCSI targets
by either entering specific iSCSI target information (IP address and iSCSI name,
see section 7.3.2) or by entering the target IP address and discovering the devices
behind that address (see section 7.3.1).
Perform the following steps to configure targets:
1. In the SANsurfer iSCSI HBA Manager main window HBA tree, select the HBA
port. Click the Target Settings tab. The Target Settings tabbed page displays
(see figure 7-3).
Figure 7-3. Target Settings Tabbed Page
The HBA port identifying information displays:
❑ HBA. HBA instance number and HBA model
❑ State. The HBA port state. See section 8.1 for details about the HBA port
state and its correspondence with the HBA icons.
❑ Green background: good
❑ Yellow background: warning
❑ Blue background: unknown
❑ Red background: bad