User`s guide

7 – Setting Up Connections
Configuring the QLA4xxx HBA Port
7-8 IS0054602-00 A
Q
7.2.2.1
Setting the IP Address Automatically
To set the IP address automatically through DHCP, do the following:
1. In the SANsurfer iSCSI HBA Manager main window HBA tree, select the HBA
port. Click the HBA Options tab; then click the Network tab. The HBA Options
tabbed page (Network tab) displays (see figure 7-2).
2. In the setting the IP Address section, select the Obtain an IP address
automatically (DHCP) option button.
7.2.2.2
Setting the IP Address Manually
To set the IP address manually, perform the following steps:
1. In the SANsurfer iSCSI HBA Manager main window HBA tree, select the HBA
port. Click the HBA Options tab; then click the Network tab. The HBA Options
tabbed page (Network tab) displays (see figure 7-2).
2. In the setting the IP address section, do the following:
a. Select the Use the following IP address option button.
b. Enter the IP address.
c. Enter the subnet mask.
d. Enter the gateway.
7.2.3
Setting the DNS Server Address
There are two ways to set the DNS server address, as described in the following
sections:
■ Automatically (through dynamic host configuration protocol (DHCP)) (see
section 7.2.3.1)
■ Manually (see section 7.2.3.2)