User`s guide

5 – Installing SANsurfer iSCSI HBA Manager
Initial Installation
IS0054602-00 A 5-3
Q
5.1.2
Installation Instructions
NOTE: This section assumes that you may be installing all SANsurfer software
components on any of the supported operating systems. References to
Solaris x86 and Novell® NetWare® do not apply to the SANsurfer iSCSI
HBA Manager application.
SANsurfer installer is a self-extracting program that installs the SANsurfer software,
including the SANsurfer iSCSI HBA Manager application and related software.
If you will be installing the SANsurfer FC HBA Manager agent on a NetWare server,
note the following:
■ You cannot install the SANsurfer FC HBA Manager agent directly on a NetWare
server; you must install the agent from a Windows 2000/Server 2003 system
connected to the NetWare server.
■ The prerequisites for each NetWare server are as follows:
❑ A Windows 2000/Server 2003 system must be connected to the NetWare
server through the TCP/IP network.
❑ The Windows 2000/Server 2003 system must have a drive mapped to the
NetWare server system volume (sys:\).
Perform the following steps to install SANsurfer iSCSI HBA Manager on this system:
1. Perform the following steps to start the installation:
a. Do one of the following to access the SANsurfer installer:
❑ If you are installing SANsurfer iSCSI HBA Manager from the SANsurfer
CD-ROM, follow these steps:
❑ Click SANblade™ HBA Software on the CD-ROM home page.
❑ Find the table that corresponds to your QLogic HBAs. Select the
appropriate operating system.
❑ From the SANblade HBA Management Software table, click
SANsurfer Software.
❑ The File Download dialog box displays. Click Save. Select a directory
on your system and download the file.
❑ If you are installing SANsurfer iSCSI HBA Manager from the QLogic Web
site, follow these steps:
❑ From the QLogic home page, click Support.
❑ Click Drivers, Software, and Manuals.
❑ Select your HBA.