User`s guide

11 – Updating the HBA
Restoring an HBA’s Firmware Parameters to the Factory Defaults
11-8 IS0054602-00 A
Q
2. From the Firmware tab Restore Factory Defaults option, click Restore.
3. The restore factory defaults message displays (see figure 11-6). Click OK to
restore the defaults. Click Cancel to not restore the defaults.
Figure 11-6. Restore Factory Defaults Message
NOTE: The restored settings do not apply to currently configured targets. To
apply the restored settings to a configured target, you must delete
and configure the target after the HBA is reset.
4. If you clicked OK to restore the factory defaults, the save firmware parameters
message displays (see figure 11-7). Click OK.
Figure 11-7. Save Firmware Parameters Message
5. Save the changes (the HBA automatically resets). Do one of the following:
❑ In the HBA Options tabbed page, click Save HBA.
❑ Right-click in the HBA tree. From the drop-down menu, click Save HBA.
6. The Security Check dialog box displays. In the Enter Password box, type the
password. Click OK.