User`s guide

11 – Updating the HBA
Configuring an HBA’s Firmware Values
11-6 IS0054602-00 A
Q
5. The save firmware parameters message displays (see figure 11-4). Click OK.
Figure 11-4. Save Firmware Parameters Message
NOTE: The revised settings do not apply to currently configured targets. To
apply the revised settings to a configured target, you must delete and
configure the target after the HBA is reset.
6. The Firmware Parameters dialog box still displays. Click Close.
7. Save the changes (the HBA automatically resets). Do one of the following:
❑ In the HBA Options tabbed page, click Save HBA.
❑ Right-click in the HBA tree. From the drop-down menu, click Save HBA.
8. The Security Check dialog box displays. In the Enter Password box, type the
password. Click OK.