Installation guide

FCoE converged network adapter (CNA) procedures

Installation and Configuration

use with FCoE adapters is v5.0.1 build 34 and is packaged with the

EMC-approved driver for the FCoE adapter.

Installing Fibre Channel BIOS and firmware on a QLogic CNA

To install the Fibre Channel firmware on your FCoE converged

network adapter, start the SANsurfer utility, shown in Figure 70, and

then follow these steps:

1. In the left pane of the utility, you will see the CNA listed under

your server host name. Click open the CNA and click on the

appropriate port number in order to view all of the possible

options in the right pane of the utility.

Figure 70 SANsurfer utility