Installation guide

48
EMC Host Connectivity with QLogic Fibre Channel HBAs and CNAs in the Windows Environment
Installation and Configuration
Figure 27 Driver handle numbers
11. Find the driver handle numbers that correspond to those listed
for the QLogic adapters (as shown in Figure 27). Note the two
digits (proceeded by Ctrl, as shown in Figure 27) next to the
driver handles for the QLogic adapters. These are control
handles.
12. Determine the adapter instance that will be used for boot, and
enter the QLogic Fibre Channel Driver Configuration Utility by
typing drvcfg -s <driver handle> <control handle> (where
driver handle and control handle are the values that correspond
to the adapter instance to be used for boot. In this example,
"
drvcfg -s 5f 62" is used.)
13. Press Enter.
The Fibre Channel Driver Configuration Utility menu will be
displayed (as shown in Figure 28 on page 49).