Installation guide

24
EMC Host Connectivity with QLogic Fibre Channel HBAs and CNAs in the Windows Environment
Installation and Configuration
Remember that some of the older adapters are tall (also referred to as
full-height) and may not fit into a server with a low-profile chassis.
These factors must be considered before implementing your
configuration to avoid unnecessary delays and possible equipment
swaps or returns.
Note: The QLogic QLE8042 FCoE CNA requires servers that can
accommodate full-height, full-length PCI Express adapters. Always refer to
the latest EMC Support Matrix for the most up-to-date information on servers
that support these adapters.
QLA2462 FC PCI-X 2.0a & PCI 2.3 64-bit 3.3V 3.3V
QLE2460 FC PCI Express x4 lane 3.3V n/a
QLE2462 FC PCI Express x4 lane 3.3V n/a
QLE220 FC PCI Express x4 lane 3.3V n/a
QLE2560 FC PCI Express x4 lane 3.3V n/a
QLE2562 FC PCI Express x4 lane 3.3V n/a
QLE8042 FCoE PCI Express x8 lane 3.3V n/a
QLE8140/8142 FCoE PCI Express x4/x8 lane 3.3V n/a
QLE8150/8152 FCoE PCI Express x4/x8 lane 3.3V n/a
QLE8242-CU FCoE PCI Express x4/x8 lane 3.3V n/a
QLE8242-SR FCoE PCI Express x4/x8 lane 3.3V n/a
QLE2670/QLE2672 FC PCI Express
Gen2/Gen3
x8/x4 lane n/a n/a
Table 1 EMC-supported QLogic adapters (page 2 of 2)
Adapter Protocol PCI spec BUS length Power Slot key