Installation guide

166
EMC Host Connectivity with QLogic Fibre Channel HBAs and CNAs in the Windows Environment
Miscellaneous Planning and Procedures
14. If the system requests that you reboot the system and you have
other adapters to update, select No and then click Close.
15. If the system again requests that you reboot the system and you
have other adapters to update, select No and then click Close.
16. If you have other adapters to update, select the next adapter
under SCSI & RAID Controllers and repeat Step 6 through
Step 15.
17. When all adapters have their drivers updated, select Yes to the
reboot prompt.
If you are not promoted to reboot, reboot your server anyway.
For more information on connecting to a SAN and installing
drivers/firmware on HP Proliant BL p-Class server blades, refer to
HP documentation on the HP Business Support site at
http://h20000.www2.hp.com/bizsupport/TechSupport/Home.jsp.
Upgrading to Windows 2003 from Windows 2000
Note the following if upgrading to Windows 2003:
◆ Upgrading from Windows 2000 - The Windows 2000 drivers may
be preserved while upgrading to Windows 2003. These SCSIPort
drivers (including the native Windows 2003 SCSIPort drivers) are
not supported by EMC for Windows 2003. You should obtain the
correct Windows 2003 drivers. Refer to “Downloading latest
QLogic drivers/firmware/BIOS files” on page 16, and reinstall
the drivers after the upgrade is complete.
◆ Currently, to upgrade from Windows 2000 to Windows 2003, you
must first uninstall PowerPath. After upgrading the host, you can
reinstall an approved Windows 2003 version. Please refer to the
EMC PowerPath documentation for further details. You may
wish to disconnect your storage during the Windows upgrade,
and reconnect it after the approved Windows 2003 drivers are
installed.