Installation guide

156
EMC Host Connectivity with QLogic Fibre Channel HBAs and CNAs in the Windows Environment
Miscellaneous Planning and Procedures
8. Select the boot LUN you wish to use.
9. Save all settings and reboot the host and load the Operating
System. Refer to “Installing the Windows operating system” on
page 55.
10. After the operating system is loaded and before the initiator
service is loaded, register the remaining paths on the CX storage
array.
11. Install the Initiator Service for Windows 2003 only. Windows
2008 has the iSCSI Initiator Service built in.
12. During the Microsoft Initiator installation, deselect the Software
Initiator. ONLY install the Initiator Service. This will attempt to
change the iqn name to fit the Microsoft naming convention.
Since this was done in Step 2, it will not blue screen the host for
an inaccessible boot device.