Installation guide

FCoE converged network adapter (CNA) procedures
105
Installation and Configuration
5. After you receive the "Your installation is complete" message, as
shown in Figure 84, click Finish.
Figure 84 Installation complete
Updating adapter firmware on a QLogic QLE8242 CNA
Before updating adapter firmware, note the following:
◆ The QLogic driver must be installed.
◆ The QConvergeConsole GUI application must be installed.
◆ Before you can perform a firmware update, the firmware file
must be downloaded from the QLogic website and extracted to a
folder on a local drive. This file could be included on
EMC-approved installation media, or downloaded from the
QLogic website.
◆ If the adapter is already connected to a boot device, the system
must be in a state in which this type of maintenance can be.
• I/O activity on the bus has been stopped.