User`s guide

SANsurfer FC HBA Manager Readme Page 10 of 13
When the qla_mp_config_required flag is set to 0, the driver reports both persistently-
bound and new targets to the OS. This is equivalent to persistent plus new.
NOTE: After saving the qla_mp_config_required parameter to the configuration file, the
driver ignores the old English-style persistent binding entries. For example:
hba<#>-SCSI-target-id-<#>-fibre-channel
-port-name="<device WWPN>";
6.5 NetWare
6.5.1 Operating SANsurfer FC HBA Manager on NetWare 5.x and 6.x
Servers
Operating SANsurfer FC HBA Manager on NetWare 5.x and 6.x servers requires the IPX/SPX
network protocol.
6.5.2 Operating SANsurfer FC HBA Manager on NetWare
To run SANsurfer FC HBA Manager on NetWare, you must modify the FILES and BUFFERS
parameters in the CONFIG.SYS file (located on the NetWare server boot drive) as shown in
the following example:
FILES = 100
BUFFERS = 50
6.6 Mac OS X
6.6.1 Persistent Binding
Bind By Port ID is not supported. The default driver setting is Bind By the WWPN.
6.7 VMware ESX
6.7.1 Operating SANsurfer FC HBA Manager on ESX 3.5 Servers
Flashing and updating NVRAM has been disabled for QLE25xx Adapters on ESX 3.5U2.
7 Known Issues and Workarounds
Known Issue Workaround
File Choosers: Periodically, the File Choosers in
SANsurfer FC HBA Manager do not respond when
trying to traverse the file system by double-
clicking the icons.
Select the directory and click the Open button to
traverse the directory or open a specific file.
Port Incorrectly Displayed in Adapter in
Topology: Depending on specific switch zoning
configurations, an attached port may appear in the
Topology as an adapter when it is not actually an
adapter.
None. For your information only.