User`s guide

6 – Getting Started
Specifying the HBA Driver Settings
6-18 FS0054603-00 C
Q
Perform the following steps to set the HBA driver parameters:
1. In the SANsurfer FC HBA Manager main window HBA tree, select the HBA.
2. Select the Settings tab. The HBA Driver Settings tabbed page displays (see
figure 6-12).
Figure 6-12. HBA Driver Settings Tabbed Page
The identifying information displays:
❑ Hostname. The name or IP address of the host connected to the HBA
❑ HBA Model. The QLA200/QLA2xxx HBA
3. In the Group: Persistent section, select one of the following to specify whether
only targets configured using SANsurfer FC HBA Manager are seen by the
system:
❑ If you want the system to see all targets at all times whether or not the target
was configured with SANsurfer FC HBA Manager, select the Present
targets that are persistently bound plus any new target(s) found radio
button.
❑ If you want the system to see only targets configured using SANsurfer FC
HBA Manager, select the Present targets that are persistently bound
Only radio button.