User`s guide

5 – Installing SANsurfer FC HBA Manager
Initial Installation
FS0054603-00 C 5-3
Q
5.1.2
Installation Instructions
SANsurfer installer is a self-extracting program that installs the SANsurfer FC HBA
Manager application and related software.
NOTE: If a previous version of SANsurfer FC HBA Manager (or SANblade
Manager) exists, uninstall it before proceeding.
If you will be installing the SANsurfer FC HBA Manager agent on a NetWare server,
note the following:
■ You cannot install the SANsurfer FC HBA Manager agent directly on a NetWare
server; you must install the agent from a Windows 2000/Windows Server 2003
system connected to the NetWare server.
■ The prerequisites for each NetWare server are as follows:
❑ A Windows 2000/Windows Server 2003 system must be connected to the
NetWare server through the TCP/IP network.
❑ The Windows 2000/Windows Server 2003 system must have a drive mapped
to the NetWare server system volume (sys:\).
Perform the following steps to install SANsurfer FC HBA Manager on this system
or on the NetWare server connected to this system:
1. Perform the following steps to start the installation.
a. Do the following to access SANsurfer installer from the QLogic Web site:
❑ From the QLogic home page, click Support.
❑ Click Drivers, Software, and Manuals.
❑ From the OEM and ISV approved/recommended drivers and
firmware section, click EMC.
❑ Locate the table that corresponds to your HBA.
❑ In the SANsurfer row of the table (SANsurfer for Windows, SANsurfer for
Linux, or SANsurfer for Solaris), click Download.
❑ The File Download dialog box displays. Click Save. Select a directory
on your system and download the file.